Montarbo W18A Owner's Manual download pdf (Page 5)

W18A

bi-amped, active loudspeaker system

ENGLISH

Control and connection panel

1 The W18A speaker system is equipped with XLR male (OUT)

and female (IN) parallel connected sockets allowing easier

daisy-chaining.

❚ Mixer output ➔ W18A input ('IN' socket)

❚ W18A output ('OUT' socket) ➔ input ('IN' socket) of the W18A

to be connected in parallel.

☛ See 'connectors' and 'connection examples' at pages 12

and 13.

2 Main volume (VOL). Adjusts the input levels of the two built-in

power ampliﬁers to adapt them to the output level of the mixer.

3 High frequencies level control (H.F.).

NOTE: if you are using a Montarbo mixer (or any mixer having an

output level of 0dB) for optimum performance it is advisable to set

both controls fully clockwise (to their maximum settings).

4 POWER / 0 - I: Mains power on/off switch.

5 Mains power cord socket (with built-in fuse).

Use only the factory supplied mains cable or a suitable cable with

a ground connection and marked with the safety approvals valid in

the country of use.

When installing make sure that it is easy to get to this connector

and to the mains plug.

FUSE REPLACEMENT

Service fuse

Spare fuse

1 2 3 4 5 6 7 8 9 10 ... 14 15

No comments

Montarbo W18A Owner's Manual Page 5